The Tamil Nadu Factories Rules, 1950
Arrangement of Rules
G.O. No. 1041 of 1950 · Tamil Nadu · 68 chapters and schedules, 167 rules
SCHEDULE V
SCHEDULE V
1. Special rule for printing presses
In printing works, every platen machine driven by power shall be fitted with an efficient, finger-guard and every guillotine machine, driven by power, with an efficient knife-guard.
2. Special rule for jute mills
In Jute mills-
(a) the feed table of every softener machine shall, as far as practicable, be not less than 1.5 meters in length;
(b) the feed table of such softener machine shall be provided with an automatic knocking off device which shall stop the machine in case the worker's band is drawn in and prevent the hand from reaching the spiked rollers; and
(c) the automatic device mentioned in clause (b) shall be maintained in an efficient state and be kept in position whenever the machinery is working.
3. Special rule for tea factories
In tea factories, the roll table shall be fenced to the satisfaction of the Inspector and brushes shall be provided to the workers for the purposes of sweeping the roll table.
4. Special rule for bricks and tiles works
In brick and tile works, a finger-guard shall be fitted at the feed end to the full length of the mould of every revolving press.
5. Special rule for decorticating factories
In decorticating factories, the beater arms and the feed mouth of the decorticator shall, as far as practicable, be guarded as follows: A grating of 19 millimeters diameter wrought iron rods spaced 64 millimeters apart and supported by iron stiffeners 5.1 centimeters by 6 millimeters thick shall be fixed at a height of 15.2 centimeters above the tip of the beater arms. A strong wooden plank 38 millimeters thick and iron plated on the underside shall be clamped with bolts and nuts over this grating leaving a space of 20.3 centimeters wide for the feeding of groundnuts. A grating of 2.5 centimeters diameter wrought iron rods spaced 38 millimeters apart shall be fixed at a height of 12.7 centimeters just above the feed mouth and another wooden plank 22.9 centimeters wide shall be fixed over the full length of the decorticator platform.
6. Special rules for factories in which polishing and grinding machinery are in use
Safety devices
(a) All collars, set screws, shafts, couplings, clutches, keys, pulleys, keys and belts in polishing and grinding machines shall be effectively guarded.
(b)
(i) Defective wheels shall not be used.
(ii) Grinding wheels shall fit freely on their spindles. They shall never be forced on, nor shall they be let loose on spindles.
(iii) The soft metal bushings at the centre shall not extend beyond the sides of the wheels. Wheels shall be kept as true as practicable and work rests shall be kept adjusted close to wheels.
(iv) Wherever possible. a compressible medium, such as blotting paper, rubber or similar material, at least as large III diameter as that of the flanges, shall be fitted between a wheel and each of its flanges.
(v) Projecting arbor ends of grinding and polishing wheels shall be effectively guarded.
(c) Except with the written permission of the Chief Inspector no emery or abrasive wheel shall be kept unprovided with a strong iron cover guard that shall enclose the wheel as far as practicable to retain fragments in the event of bursting. The guard shall be securely attached to the frame of the machine or other solid foundation.
(d) Where workers are employed continuously on dry grinding or polishing wheels, such wheels shall be provided with an efficient exhaust system capable of drawing off dust particles.
(e) Wheels shall not be operated at a speed in excess of that which is recommended by the manufacturer.
