NextGen Socio & Enviro Advisors

The Tamil Nadu Factories Rules, 1950

Arrangement of Rules

G.O. No. 1041 of 1950 · Tamil Nadu · 68 chapters and schedules, 167 rules

SCHEDULE XXIV

FIRE WORKS MANUFACTORIES AND MATCH FACTORIES

1. Application

The provisions of this Schedule shall apply to all manufactories and processes incidental thereto carried on in any Fire Works Manufactory or a match works and shall be in addition to and not in derogation of any provisions of the Factories Act, 1948 and the Tamil Nadu Factories Rules, 1950 or of any other Act or Rules that are applicable to fireworks manufactories and match factories.

2. Definition

(a) "Fire Works Manufactory" means any factory or such parts of any factory wherein the following chemicals or combination of chemicals and materials are being used for the manufacture or crackers, sparklers, caps, fuses, blasting powder and fireworks Saltpetre; Pyrotechnic aluminium Powder; Barium Nitrate; Charcoal; Potassium chloride; Red Phosphorus; Gum; Dextrine; Strontium Nitrate; Magnesium Powder; Copper Coated Wires; Steel filings or iron filings; G.I. Wire; Gun Powder (Black Powder);

(b) "Match works" means any establishment which manufactures safety matches or colour matches by the use of chemicals mentioned in clause (a).

(c) "Breathing apparatus" means a device covering mouth or nose with necessary connections by means of which a person using it in a poisonous asphyxiating or irritant atmosphere breathes ordinary air or any other suitable apparatus approved in writing by the Chief Inspector in this behalf.

3. Buildings

(a) The building of any fireworks manufactory or match factory shall conform to the standards prescribed under the Indian Explosives Act 1884 (Central Act IV of 1884), and the height of such buildings shall at no time be less than 3 meters;

(b) No building inside a fireworks manufactory shall have a first floor at any time:

(c) In Match works, provided with a first floor, there shall be 2 staircases leading from the first floor to the ground floor irrespective of the number of persons employed in the first floor and one of the staircases shall be of masonry construction or of non- inflammable materials;

(d) All doors shall open outwards and all the doorways shall be kept free from obstructions;

(e) All doors of workrooms shall not be less than 1.2 meters in width or less than 2 meters in height; 233

(f) [The floors of all work rooms including mixing sheds shall be completely covered by a rubber sheet having a smooth surface and having a thickness of atleast 3 mm. If the floor cannot be covered by a single rubber sheet, more than one rubber sheet may be used, so that each sheet is overlapped by the other atleast 150 mm; and] 234

(g) [Mixing sheds in a fireworks manufactory shall be at a distance of 18 meters away from all other sheds if the quantity of chemical stored, handled or used in the mixing shed is less than 50 kilograms and be separated by baffle walls opposite to each exit of the mixing shed:

Provided that the distance shall be at least 21 meters, if the quantity of chemical stored, handled or used in the mixing shed exceeds 50 kilograms.]

4. House-keeping

(a) Every part of ways, works, machinery and plant shall be maintained in a clean and tidy condition;

(b) Any spillage of materials shall be cleaned without delay;

(c) Close platforms, passages and gangways shall be kept free of temporary obstructions.

5. Electrical Equipment

(a) If at any time, use of electricity is allowed in the factory, all leads, etc., shall be in conduits with flame-proof junctions;

(b) Electrical supply shall never be through a lamp even with a non-conducting handle.

6. Protective clothing

(a) Under no circumstances clothes made of artificial fiber like terelene, etc., be allowed inside the factory;

(b) All workers shall be supplied with asbestos aprons especially to cover the chest, gonads and thighs

(c) Breathing apparatus shall be used in mixing sheds to avoid workers inhaling poisonous fumes in the event of an untoward reaction.

(d) In mixing sheds where aluminium and magnesium powders arc used "anti-stat" foot- wear to combat static electricity shall be supplied.

(e) All protective equipments shall be maintained in an efficient condition and also shall be maintained in a clean and hygienic condition.

7. Match Factories

In mach factories --

(i) the residue of the head composition shall not in any way be mixed with the residue of the friction composition;

(ii) the rooms comprising the two mixing departments, namely, (a) head composition and (b) friction composition shall be entirely separated from each other and the drains from these two departments shall be kept entirely separate;

(iii) rubbish containing the residues of the head composition and friction composition shall be kept and burnt separately;

(iv) department in which completed matches (matches with heads on) are stored shall be separated from all other departments by means of fire-proof walls and doors providing adequate means of escape in case of fire:

Provided that the Chief Inspector may, subject to such conditions, as he may deem necessary, exempt any factory in existence on the first January 1935, from the provisions of this clause;

(v) Splints, veneers and other materials in excess of the quantity required for the day's manufacture shall be kept in separate rooms of the factory where no manufacturing process is carried on. No manufactured material shall be stored anywhere in the factory compound for more than five days after the manufacture except in the storage godowns:

Provided that nothing contained in this clause shall apply to splints and veneers in cases stored in peeling and box making departments;

(vi) Store room for matches shall be entirely separated by fire-proof walls from the 235 buildings used for manufacture [* * *] 236

(vii) [The racks in the dipped splints room shall have sides top and the rear part provided with non-inflammable materials.] 237

(viii) [The process of packing shall be done in an area away from the place of manufacture to the satisfaction of the Inspector; and 238

(ix) No child shall be employed or permitted to work [in any process] directly connected with the manufacturing process up to final production of match sticks.]

8. Precautions to be taken in connection with manufacture of fuses used in crackers, etc

(a) Bundles of fuses shall be handled by carrying and not dragging them on the floor;

(b) Drying of fuses after wrapping shall be carried out on platforms away tram workrooms;

(c) Cutting shall be done by experienced workers employed only for this purpose and under proper supervision;

(d) Cutting shall be done on a large masonry platform covered with a tarpaulin and kept free from grit and pebbles;

(e) Cutting shall be done on a raised platform so that workers can work standing. Cutting must be done by placing the fuse on wooden sleepers kept over blocks of wood. Brick shall not be used beneath the wooden reapers; and

(f) Workers, while on dangerous operations, shall not wear clothing sewn with ferrous or steel buttons, buckles or attachments. They shall not carry on their persons, iron knives, keys, etc.

9. Employment of women and children

239 [Women workers and Young persons shall not be employed on operation where chemicals arc mixed and where fuses are cut. Children shall not be employed or permitted to work in the manufacturing process or any work or operation or process connected therewith or incidental thereto in fireworks manufactory.]

10. General

(a) No person other than a factory worker and/or an inspecting officer or others connected with the manufacturing process shall be allowed to enter the working area;

(b) Cardboard containers and trays without steel nails shall be used for storage and day- to-day working purposes.

(c) During the manufacture of fuses only brass or non-ferrous knives shall be used and drying of fines shall be away from all workrooms.

(d) Door mats shall be provided outside the workroom and near all drying platforms and where fuses are cut for the workers to clean their feet.

(e) At no time, mixing materials shall exceed the quantity that is required for the manufacture of mixing for half an hour operation only.

(f) For filling up chemicals in the inner tubs of crackers, only aluminium or plastic rings shall be used and not galvanized iron rings.

(g) Buckets, containers, hoops, locks, nails, screws, bolts, nuts, knives, scissors, i[hinges, latches] etc., made up of iron shall not be used within the factory premises.

(h) Wooden racks without iron nails shall be used for drying paper cap sheets, in amorcess factories.

(i) Wooden racks used for drying paper cap sheets shall be provided with asbestos or other fire resistant sheets on the three sides leaving the front side open.

(j) Dried paper cap sheets shall be carried in wooden trays with four compartments (partitions) each compartment (partition) carrying a single sheet.

(k) Each manufacturing shed of fireworks shall have atleast two doors facing each other. The doors provided to the work sheds of adjacent rows shall not face each other.

(l) Not more than four persons shall be employed or allowed at any one time in any one building in which explosive is being manufactured.]

(m) Copper plates shall be fixed on the baffle wall of the chemical mixing shed and chemical filling shed; and the workers before entering those sheds, shall place their hands on the copper plates in order to discharge the electrostatic charges from their body and to protect them from any untoward fire or explosion.

(n) Workers aged above 55 years shall be employed only in non-explosive areas.

(o) No person, aged 50 years and above shall be employed in Fireworks Manufactory unless his eyesight including colour vision and his hearing capacity are examined and declared fit by a qualified ophthalmologist and ENT specialist, respectively, to work whether with or without use of corrective appliances. Such examinations shall be made atleast once in every two years. Record of examination or re-examination carried out shall be produced on demand to Inspectors at the time inspection.

(p) Work benches and tables shall be provided for mixing and filling operations.

(q) Blast walls shall be provided around the drying platform at a distance of 2 meters away from the drying platform. The height of the blast wall shall be atleast one foot more than that of the height of the drying platform.

(r) In every Fireworks Factory, there shall be appointed a Supervisor with minimum qualification of B.Sc. (Chemistry) or Diploma in Chemical Engineering or its equivalent. He shall be fully conversant with the process of manufacture of fireworks and the associated hazards. These Supervisors shall undergo special training of fireworks safety as approved by the Chief Inspector of Factories. Number of Supervisors shall be at the rate of 1 for every 50 workers. Manufacture of fireworks shall be carried out under the supervision of such Supervisors.

(s) Factories which make fancy crackers shall have,

(i) separate colour pellet machine shed;

(ii) separate colour pellet drying shed; and

(iii) separate transit rock for storing colour pellets.

(t) Not more than one manufacturing activity at any one item of crackers shall be allowed or required to be done in any working shed at a time.

(u) The workers involved in mixing and filling operations shall have an education qualification of atleast Higher Secondary Course.

(v) The drying platform meant for Rockets and Fire Works of flying nature shall be provided with a temporary roof of a strong aluminium mesh cover resting on the baffle wails, for protection from direct sunlight.

(w) There shall be provided atleast two burning pits in every factory and each burning pit shall be at a minimum distance of 62 meters away from the working sheds.

(x) The collected waste shall be disposed in the burning pit after the working hours of the factory on the same day in the presence of the Foreman by a trained worker.

(y) Wind direction indicator shall be provided in each factory.

(z) No electronic appliances such as mobile phones, transistors etc., shall be allowed in the premises, where fireworks are manufactured, handled, stored or used.

(aa) The mixed chemicals shall be used on the same day. No mixed chemical (fireworks) composition, dry or wet shall be kept in the factory at the close of any working day. Such residual composition shall be safely destroyed at the close of the day.

(ab) Fireworks factory ordinarily employing 250 workers or more shall appoint a qualified Safety Officer as per the Tamil Nadu Safety Officer (Duties, Responsibilities and Conditions of Serves, 2005 at the rate of one Safety Officer for 250 workers.

(ac) No manufacturing activity shall be carried on in Fireworks factory between 6.00 pm. And 6.00 am.]

11. Display of notices

The following notices in the local language understood by the majority of workers shall be displayed at a conspicuous place in the factory.

(a) Smoking is strictly prohibited.

(b) No one shall carry matches or other igniting materials into the factory.

(c) No worker shall be in a workroom or area where no work has been assigned to him.

(d) If anything untoward happens in any shed all workers shall dash to the gates which serve as outgates of the factory and in no circumstances be curious to see what has happened in the affected shed.

(e) Any spillage of materials should be cleaned without any delay.

(f) Wearing of clothes made of artificial fiber like terene, etc., is prohibited. Clothing ’ s sewn with ferrous or steel buttons or buckles or attachments should not be worn.

(g) Foot wears with iron nails should not be used-(It) Workers should not carry with themselves iron knives and iron keys, etc.

12. First-aid boxes

(a) The materials required under rule 65 shall be kept in the First-Aid Box. In addition, four stretchers shall be available for every twenty persons employed in the premises.

(b) Adequate amount of burn dressings and 24 ounces of coconut oil to be used as the first remedy for burns shall be kept in the First-Aid Box.

(c) Persons who are in charge of First-Aid Boxes shall be those who possess the certificate granted by the St. John's Ambulance Association for rendering first-aid.

12-A Personal Accident Insurance 240 [The occupier of every factory wherein the manufacture of match or fire work is carried on shall prepare a report containing the details of the insurance coverage in respect of the workers employed, in such factory in Form No. 41 and sent it to the Chief Inspector once in sex months through the Deputy Chief Inspector of Factories having jurisdiction over the area where the factory is situated]

13. Exemption

If the Chief Inspector is satisfied in respect of any factory or any process that, owing to the special conditions or special methods of work or by reason of the frequency of the process or for other reason the application of all or any of the provisions of the schedule to the factory or process, or for the persons employed in such factory or process is not necessary, he may by order in writing exempt such factory or part of the factory or process or any part of the factory or person from all or any of these provisions subject to such conditions as he may deem expedient to ensure safety and health of the workers. The Chief Inspector may at any time in his discretion revoke such order without assigning any reason.